Make this gorgeous crochet flower necklace (Pattern by Linda Permann) with just a few materials and a little bit of time! The necklace matches these earrings!
*This most may contain affiliated links. For more information on this, please see my Disclosure page!*
Materials:
- Thread Yarn in White
- Thread Yarn in Black
- Crochet Hook Size (B/1-2.25MM)
- Sew on Snaps
- Sewing and Tapestry Needle and thread (I used transparent)
- Scissors
Notes:
A= White
B= Black
Leave long thread tails on each piece for sewing shapes together later.
Flower:
(Make 7: 3 flowers using A for centers and B for petals; 4 flowers using B for centers and A for petals.)
With center color, ch 6; join with a slip st in first ch to form a ring. Center-Rnd 1: Ch 3, 2 dc in ring, ch 7, [3 dc in ring, ch 7] 4 times; join with a slip st in top of ch-3. Fasten off.
Petal-Rnd 2: With right side facing, join petal color in center dc of any 3-dc group; ch 3, 15 dc in next ch-7 space, * skip next dc, dc in next dc, skip next dc, 15 dc in next ch-7 space; repeat from * around; join. Fasten off.
Circle:
(Make 3: 2 with A and 1 with B.)
Ch 9; join with a slip st in first ch to form a ring. Rnd 1: Ch 3, 17 dc in ring; join with a slip st in top of ch-3. Fasten off.
Medallion:
(Make 3: 2 with A and 1 with B.)
Ch 9; join with a slip st in first ch to form a ring. Rnd 1: Ch 3, 17 dc in ring; join with a slip st in top of ch-3. Rnd 2: Ch 3, dc in same st as joining, ch 1, skip next dc, * 2 dc in next dc, ch 1, skip next dc; repeat from * around; join in top of ch-3. Fasten off.
Small Leaf:
(Make 3: 1 with A and 2 with B.)
Ch 9. Rnd 1: Sc in 3rd ch from hook, hdc in next 2 ch, dc in next 3 ch, 8 dc in last ch; pivot to work along opposite side of foundation ch, dc in next 3 ch, hdc in next 2 ch, sc in next ch; join with a slip st in first sc. Fasten off.
Large Leaf:
(Make 2: 1 with A and 1 with B.)
Ch 9. Rnd 1: Repeat Rnd 1 of Small Leaf. Do not fasten off. Rnd 2: Ch 1, sc in first sc, ch 1, * sc in next st, ch 1; repeat from * around; join with a slip st in first sc. Fasten off.
Assembly:
Arrange pieces according to diagram. Using a tapestry needle, sew shapes together with thread tails. Weave in any remaining ends. Cut off excess.
Cord:
Chain 1: Join thread in left side of piece at joining location as shown in diagram; ch 110. Leave a long yarn tail at end of chain and do not knot.
Work two more cords as for Cord Chain 1. Loosely braid the three cord chains and measure against your neck. If the length is comfortable, knot the three chains together at this length, leaving only 3–4 chains on each strand after knot. If length is too long, pull out last few chains of each strand to achieve desired length and knot together, leaving only 3–4 chains on each strand after knot. With tapestry needle, sew ends into knot.
Sew snap socket onto knot and corresponding stud onto flower petal as shown in diagram. Sew second snap socket onto braided strand approximately 1” from first snap. Sew corresponding stud to tip of leaf as shown in diagram. Weave in all ends. NOTE: I chose not to add the second snap as suggested.
If you made the earrings from my previous post, then you’ll have a wonderful jewelry set to wear at your next special event!
